Honeywell 800-08091V3 manual Automation contd, Remove/Delete a Honeywell Thermostat, Icon

Automation (cont'd)

Remove/Delete a Honeywell Thermostat

To remove a Honeywell Thermostat from the Z-Wave network, do the following:

ICON		ACTION	NOTES
	1. At the Tuxedo Touch Keypad:
	a) Press the Automation icon from the “Home” screen,		IMPORTANT: Honeywell is not responsible for property damages
		and then press the Z-Wave Setup icon to display the	due to improper setting of the thermostat modes.
	b)	“Z-Wave Device Management” screen.
		Highlight the thermostat and press the Z-Wave
		Remove/Delete icon.
	2. At the thermostat:		Z-Wave Remove/Delete -clears the node from the keypad and
	a)	Follow the instructions in the thermostat	resets device to the default setting.
		Installation Guide under “Installer setup” to “Remove
	b)	a Z-Wave Network Connection”.	Note: To remove a defective device, refer to the “Z-Wave
		Once the exclusion process is complete, press Done;	Troubleshooting” section.
		the thermostat is removed.

Remove All Z-Wave Devices

ICON		ACTION		NOTES
	1. At the Tuxedo Touch Keypad:			The message is displayed:
	a) Press the Automation icon from the “Home” screen			WARNING!! This Z-WAVE controller is about to be factory
		and then press the Z-Wave Setup icon to display the		defaulted and will loose all devices in the enrolled list. All
	b)	“Z-Wave Device Management” screen.		Z-WAVE devices must be re-enrolled.
		Press the Z-Wave Reset icon to delete all devices
	c)	from the controller.
		Press the Continue or Cancel button.
Abort a Z-Wave Action
ICON		ACTION		NOTES
	1. At the Tuxedo Touch Keypad:		If inadvertently a wrong selection was made, (add, delete, or remove failed
	a) Press the Automation icon from the “Home”		device) user can press the Z-Wave Abort icon to abort the process.
	screen and then press the Z-Wave Setup
	icon to display the “Z-Wave Device
	Management” screen.

b)Press the Z-Wave Abort Operation icon to abort that process.

36