Automation (cont'd)
Remote Services
The Tuxedo Touch™ supports Remote Services for controlling
The following describes the related features:
•Tuxedo Touch [automation] can be controlled from a smart phone,
•Automation scenes can be created in both Total Connect and Tuxedo Touch (Scenes created in Total Connect can be edited only via Total Connect)
•Scenes created in Total Connect can be viewed from either Total Connect or directly from Tuxedo Touch using the Remote selection on the Tuxedo Touch scenes page
•Scenes created in Tuxedo Touch cannot be viewed from Total Connect.
NOTE: It is assumed that
The following table summarizes the relationships between Total Connect scenes and Tuxedo scenes:
Controlling
Device
Total Connect
Tuxedo
Scenes created in Total Connect | Scenes created in Tuxedo | ||
|
|
|
|
View | Edit Scenes | View | Edit Scenes |
|
|
|
|
yes | yes | no | no |
|
|
|
|
yes | no | yes | yes |
|
|
|
|
NOTE: For troubleshooting purposes, Total Connect server information (including IP addresses) can be viewed on the Total Connect Server Setup screen by pressing the TC Server Info button (see next page).
Remote Services Setup
NOTE: If used for Remote Services, Tuxedo Touch should not be configured as a secondary controller.
To use Remote Service, do the following:
1.Verify the Tuxedo is connected to the Internet via its Ethernet connector.
2.Enable AlarmNet Direct, enroll the communication device and Tuxedo keypad, and enable Total Connect usage. The screen displays “using Tuxedo Automation Module” (Yes /No); select Yes. You will need the Tuxedo keypad’s MAC ID and CRC
number, which can be found on a label on the back of the Tuxedo keypad or on its carton.
NOTE: Only the Primary keypad (if there is more than one in the same installation) can be enrolled into Total Connect.
3.Open a Total Connect account for the user if an account does not already exist.
4.After a Total Connect account has been set up, the Tuxedo Keypad must be reset (powered down and powered up).
5.Enable automation devices to be controlled by Total Connect. See “Enabling Devices for Total Connect“. After devices have been enabled for Total Connect, follow the Total Connect prompts to synchronize the data with Tuxedo. Syncing is required before the enabled devices will display in Total Connect.
41