Honeywell 800-08091V3 manual User Codes, Extended Functionality, LED Operation, Safe Mode

About the System (cont'd)

User Codes

Each user must be assigned a name with a corresponding 4-digit user code in order to gain access to authorized features and functions. Users for the system are programmed in a central user setup location that provides the specific questions for authorization level, partition assignment, and RF zone assignment.

Extended Functionality

Extended functions are advanced functions that can be accessed through a standard alpha keypad or through the console emulation mode on the Tuxedo Touch touch-screen. Refer to the Control Panel User Guide for these features.

LED Operation

The Tuxedo Touch Keypad has three LEDs as follows:

SD/SDHC CARD Slot

ARMED (RED) LED

ON – System is armed.

OFF – System is not armed.

READY (GREEN) LED

ON – System is disarmed and ready to arm.

OFF – System is armed or disarmed but not ready. If disarmed, faults or troubles are present.

MESSAGE (YELLOW) LED

FLASHING – The system contains new message(s) for the User.

OFF – No new messages.

RESET BUTTON
Press to reset keypad	6280-001-V0

NOTE: If the Screen Blackout feature (*EN50131 Display) is enabled (see below) the keypad returns to the “Home” screen and the “Armed” and “Ready” status LEDs turn OFF after 30 seconds. The keypad will remain in this state until a valid user code is entered.

*The EN50131 Display compliance feature is a European Standard designed to prevent unauthorized users from viewing the status of the Security System.

Safe Mode

The Keypad contains a Safe Mode of operation. In the rare event that the keypad cannot successfully communicate in its graphic mode with the control panel, the Safe Mode is a backup mode that ensures that you can communicate with your system. Refer to the Safe Mode section for further information.

9