Automation (cont'd)
Updating Controllers (Keypads) with New or Removed devices
When devices are added or removed from the
ICON |
| ACTION | NOTES | |||||
|
|
|
| 1. | Press Add on Primary controller. | The controller scans for device changes. | ||
|
|
|
| |||||
|
|
|
|
|
| 2. | Press Add on Secondary controller. | The message is displayed: “Devices added Successfully” |
|
|
|
|
| ||||
|
|
| ||||||
|
|
|
|
|
|
|
|
|
Removing a Secondary Controller (Keypad)
To remove the Secondary controller, do the following:
ICON | ACTION | NOTES |
| 1. At the Primary Controller keypad: | Both keypads will display, “Device Removed” and the Secondary Controller |
| a) Press Delete. | keypad will revert back to the Primary Controller. |
2.At the Secondary Controller keypad:
a)Press Delete.
Z-Wave Troubleshooting
PROBLEM |
| SOLUTION |
Cannot add new | Make sure the | |
device. | device closer to the keypad. Refer to the | |
Device is within | 1. | At the Tuxedo Touch Keypad: |
proper range but still |
| a) Press the Automation icon from the “Home” screen and then press the |
is not enrolled. |
| |
|
| b) If the device does not appear on the screen, press the |
| 2. | At the |
|
| “Device Removed”. |
3.At the Tuxedo Touch Keypad:
a)Enroll device again.
Highlighted device | When deleting a device, if the selected device remains on the screen, highlight the device |
will not delete. | name and press the Removed Failed Device icon. |
40