ENGLISH
IMPORTANT
1.In order to carry out safe and proper installa- tion of the product, please read this booklet carefully beforehand and follow the instruc- tions contained within.
2.On completion of the installation, start the icemaker to check for any abnormalities, and instruct the user on how to use and maintain the icemaker in accordance with the Instruc- tion Manual.
3.This booklet should be handed over to the user after the installation and be preserved by the user together with the Instruction Manual for any further consultation that may be necessary.
WARNING
The installation must be carried out by qualified personnel, in accordance with current regulations, according to the manufacturer’s instructions.
4)Remove the protective plastic film from the panels. If the icemaker is exposed to the sun or to heat, remove the film after the icemaker cools.
5)Check that the refrigerant lines do not rub or touch lines or other surfaces, and that the fan blade turns freely.
6)Check that the Compressor is snug on all mounting pads.
7)See the Nameplate on the Rear Panel, and check that your voltage supplied corresponds with the voltage specified on the Nameplate.
8)Remove the shipping tapes securing the Cube Guide.
2. HOW TO REMOVE PANELS - See Fig. 1
1. UNPACKING
WARNING
Children should not be allowed in reach of the packaging elements (plastic bags and expanded polystyrene) as they are potential sources of danger.
CAUTION
Remove shipping carton, tape(s) and packing. If packing material is left in the icemaker, it will not work properly.
Note: 1. This icemaker needs a storage bin. The recommended storage bin is HOSHIZAKI ICE STORAGE BIN, Model
2.The remote
HOSHIZAKI REMOTE CONDENSER UNIT, Model
1)After removing the packaging, make sure that the icemaker is in good condition. If in doubt, please do not use the equipment but apply to professionally qualified personnel. See the instruction sheet at- tached to the Storage Bin for its unpacking and installation guidelines.
2)Remove the panels to prevent damage when installing the icemaker. (See “2. HOW TO REMOVE PANELS.”)
3)Remove the package containing the accessories from the compressor compartment.
Fig. 1
a)Front Panel . . . . . Remove the two screws. Lift up and pull toward you.
b)Top Panel . . . . . . Remove the two screws, and then lift off.
c)Side Panel (R) . . .Remove the screw.
Pull slightly toward you, and take off.
d)Insulation Panel . . Remove the Thumbscrew. Lift up slightly, and pull toward you.
2
