Replacing Assemblies
To remove and replace the HP 16500L interface module
To remove and replace the HP 16500L interface module
HP 16500B and HP 16500L
1Using previous procedures, remove the following assemblies:
• Top cover
2If your system includes an expansion frame, disconnect the interface cable from the HP 16500L interface module by pressing the release tabs on either side of the cable connector while pulling the connector away from the card.
3Disconnect the cable from the HP 16500L interface module to the CRT monitor and the two cables from the HP 16500L interface module to the CPU card.
4Remove the two screws connecting the HP 16500L interface module to the sheet metal plate and the four screws connecting the HP 16500L interface module to the mainframe rear panel.
5Slide the card out the back of the mainframe.
6Insert the replacement card in the back of the mainframe, then install the screws and connect the cables.
The module serial number is located on the module rear panel. If you need to keep the same serial number with your system, then remove the rear panel from the old interface module and install it on the replacement module. The module rear panel is connected to the module circuit board with four screws.
