•Unauthorized, couldn't find RIB object
•Unauthorized, no readable roles
•Unable to read restrictions on object
•Time Restriction Not Satisfied
•IP Restriction Not Satisfied
•Unauthorized
Directory Server connect failed
The RILOE II was not able to connect to the LDAP server. Be sure that the Directory Server Address on the RILOE II Directory Settings Screen is correct, and that the port number corresponds to the LDAP SSL port number used by that directory server, usually port 636. If the directory server address is a DNS name, be sure that the DNS server is properly configured on the RILOE II Network Setting Screen, and that the DNS name of the directory server resolves to the appropriate address using "nslookup" or a similar tool.
Many SSL problems are reported with this error; be sure your directory server is properly configured for LDAP SSL connections. Refer to the installation prerequisites for Active Directory ("Active Directory installation prerequisites" on page 83) or eDirectory for more information on testing LDAP SSL configurations.
Invalid credentials
The directory server has denied the authentication request. If configured, check the searchable contexts to be sure the user exists in one of those contexts, or try specifying a fully distinguished name. Directory servers will deny the authentication request if the user account has been disabled, locked out, or is otherwise prevented from authenticating due to network address or time restrictions placed on the account.
This error is common on eDirectory when periods are used to separate the name components, or the components are partially specified. LDAP distinguished name components are separated by commas, not periods, and must be preceded by cn=, or appropriate naming attribute name.
NOTE: The short form of the login name by itself does not tell the directory which domain you are trying to access. You must provide the domain name or use the LDAP distinguished name of your account.
Invalid Directory Server address or port
The specified Directory Server address was empty, or the port number was set to 0. Specify the correct server address or port.
Directory Server timeout
The server did not acknowledge the bind request within a reasonable amount of time, normally 20 seconds. The server may be under heavy load or otherwise unwilling to process the request. Try again later.
This error can also occur if the Directory Server address and port correspond to a service other than LDAP SSL.
Unauthorized, couldn't find RILOE II object
An error occurred while trying to read the RILOE II object. Be sure that the distinguished name specified in the Directory Settings screen matches the location of the object within the directory. The distinguished name must be a fully distinguished LDAP name.
Troubleshooting the RILOE II 186