When updating RILOE II drivers, be sure RILOE II is running the latest version of RILOE II firmware. You can obtain the latest version as a Smart Component from the HP website (http://www.hp.com/servers/lights-out).

To install the drivers download the PSP from the HP website (http://www.hp.com/support) to a NetWare server. After downloading the PSP follow the Novell NetWare component installation instructions to complete the installation. For additional information about the PSP installation, read the text file included in the PSP download.

When using Novell NetWare 6.X, use the RAGE-XL video driver that is provided by the operating system for best results.

Linux device driver support

You can download the PSP files containing the RILOE II driver, the foundation agents, and health agents from the HP website (http://www.hp.com/support). The instructions on how to install or update the RILOE II driver are available on the website. The HP Management Agents for Linux are:

•ASM package (hpasm) which combines the health driver, IML viewer, foundation agents, health agent, and standard equipment agent into one package.

•RSM package (hprsm) which combines the RIB driver, rack daemon, RIB agent, and rack agent into one package.

To load the health and RILOE II driver packages, use the following commands:

rpm –ivh hpasm-d.vv.v-pp.Linux_version.i386.rpm

rpm –ivh hprsm-d.vv.v-pp.Linux_version.i386.rpm

where d is the Linux distribution and version and vv.v-ppare version numbers.

For additional information, refer to the Software and Drivers website (http://www.hp.com/support).

To remove the health and RILOE II drivers, use the following commands:

rpm –e hprsm

rpm –e hpasm

For additional information, refer to the Software and Drivers website (http://www.hp.com/support).

Disabling DNS/DHCP

HP recommends using DNS/DHCP with the RILOE II to simplify installation. In the event that DNS/DHCP cannot be used, use the following procedure to disable DNS/DHCP and configure the network settings:

1.Restart or power up the server.

2.Press the F8 key to enter the RBSU when the cursor flashes and the RILOE II prompt displays on the screen.

NOTE: Use the arrow keys to highlight selections.

3.Select Network, DNS/DHCP, and press the Enter key. The Network Autoconfiguration screen displays.

4.Select DHCP Enable and press the space bar to turn off DHCP. Be sure that DHCP Enable is set to off and press the F10 key to save the changes.

NOTE: It will take a few minutes for the board to save the network changes and to reset.

Configuring the RILOE II 21