HP 232664-006 manual Parameter Default value Definition

When you click Apply, RILOE II restarts. During the restart process, the connection from the browser to the board is terminated. To reestablish a connection, wait 60 seconds before launching another browser session and logging in to RILOE II.

Parameter	Default value	Definition
Transceiver Speed	Yes	Autoselect detects the interface speed and sets the interface to
Autoselect		operate at 10 Mb/s or 100 Mb/s and at half or full duplex. If
		necessary, you can set this parameter to No so you can manually
		adjust the speed and duplex settings.
Speed	Autoselect	Use this parameter to assign 10-Mb/s or 100-Mb/s connection
		speeds if Transceiver Speed Autoselect is not enabled.
Duplex	Autoselect	Use this parameter to assign half or full duplex to the NIC if
		Transceiver Speed Autoselect is not enabled.
Enable DHCP	Yes	This parameter enables you to select a static IP disables (No) or
		enables the use of a DHCP server (Yes) to obtain an IP address for
		the RILOE II subsystem.
		You cannot set the RILOE II IP address and subnet mask if DHCP is
		enabled.
		Enabling DHCP allows you to configure the following DHCP options:
		• Use DHCP Supplied Gateway
		• Use DHCP Supplied DNS Servers
		• Use DHCP Supplied WINS Servers
		• Use DHCP Supplied Static Routes
		• Use DHCP Supplied Domain Name
Use DHCP	Yes	This parameter controls whether RILOE II uses the DHCP server-
Supplied gateway		supplied gateway. If not, enter one in the Gateway IP Address box.
Use DHCP	Yes	This parameter controls whether RILOE II uses the DHCP server-
Supplied DNS		supplied DNS server list. If not, enter one in the
servers		Primary/Secondary/Tertiary DNS Server boxes.
Use DHCP	Yes	This parameter controls whether RILOE II will use the DHCP server-
Supplied WINS		supplied WINS server list. If not, enter one in the
servers		Primary/Secondary WINS Server boxes.
Use DHCP	Yes	Toggles whether RILOE II will use the DHCP server-supplied static
Supplied Static		route. If not, enter one in the Static Route #1, #2, #3 boxes.
Routes
Register with	Yes	RILOE II automatically registers with a WINS server. By default,
WINS Server		WINS server addresses are assigned by DHCP.
IP Address	N/A	Use this parameter to assign a static IP address to RILOE II on your
		network. By default, the IP address is assigned by DHCP.
Subnet Mask	N/A	Use this parameter to assign the subnet mask for the default
		gateway. By default, the subnet mask is assigned by DHCP.
Gateway IP	N/A	Use this parameter to assign the IP address of the network router that
Address		connects RILOE II subnet to another subnet where the management
		console resides. By default, the gateway is assigned by DHCP.
RILOE II Board	N/A	Use this parameter to assign a unique name to RILOE II. This name
Name		can be used, if DHCP and DNS are configured as the address to
		connect to RILOE II instead of the IP address.
Domain Name	N/A	Enter the name of the domain in which RILOE II will participate. By
		default, the domain name is assigned by DHCP.
DHCP server	N/A	This parameter is automatically detected if Enable DHCP is set to
		Yes. You cannot change this parameter.
		Using the RILOE II 28