HP 43361 Screen Message, Probable Cause, Recommended Action, in Advanced > Onboard Devices, in Advanced > Onboard Devices

POST Error Messages

POST Error Messages (Continued)

Screen Message Probable Cause Recommended Action

219-ECC Memory Module Detected. ECC Modules not supported on this platform

Recently added memory module(s) support ECC memory error correction.

1.If additional memory was recently added, remove it to see if the problem remains.

2.Check product documentation for memory support information.

301-Keyboard Error	Keyboard failure.	1.	Reconnect keyboard with computer
			turned off.
		2.	Check connector for bent or missing
			pins.
		3.	Ensure that none of the keys are
			depressed.
		4.	Replace keyboard.
303-Keyboard	I/O board keyboard	1.	Reconnect keyboard with computer
Controller Error	controller.		turned off.
		2.	Replace the system board.
304-Keyboard or	Keyboard failure.	1.	Reconnect the keyboard with
System Unit Error			computer turned off.
		2.	Ensure that none of the keys are
			depressed.
		3.	Replace keyboard.
		4.	Replace system board.
404-Parallel Port	Both external and internal	1.	Remove any parallel port expansion
Address Conflict	ports are assigned to		cards.
Detected	parallel port X.	2.	Clear CMOS.
		3.	Reconfigure card resources and/or
			run Computer Setup.
410-Audio Interrupt	IRQ address conflicts with	Enter Computer Setup and reset the IRQ
Conflict	another device.	in Advanced > Onboard Devices.
411-Network Interface	IRQ address conflicts with	Enter Computer Setup and reset the IRQ
Card Interrupt Conflict	another device.	in Advanced > Onboard Devices.
501-Display Adapter	Graphics display	1.	Reseat the graphics card (if
Failure	controller.		applicable).
		2.	Clear CMOS.
		3.	Verify that the monitor is attached
			and turned on.
		4.	Replace the graphics card (if
			applicable).
510-Flash Screen image	Flash Screen image has	Reflash the system ROM with the latest
corrupted	errors.	BIOS image

Service Reference Guide, dx7300 433611-001 C–3