Removal and Replacement Procedures— Microtower (MT) Chassis

6.9 Drives

The computer supports up to six drives that may be installed in various configurations.

This Section describes the procedure for replacing or upgrading the storage drives. A Torx T-15 screwdriver is needed to remove and install the guide screws on a drive.

ÄCAUTION: Make sure personal files on the hard drive are backed up to an external storage device before removing the hard drive. Failure to do so will result in data loss. After replacing the primary hard drive, you will need to run the Restore Plus! CD to load the HP factory-installed files.

6.9.1Drive Positions

Drive PositionsItem Description

1Two 5.25-inch, half-height bays for optional drives

2Two standard 3.5-inch, one-third height bays (1.44-MB diskette drives shown)*

3Two internal 3.5-inch, one-third height bays for hard drives

*A 3.5-inch diskette drive or zip drive may be installed in this bay but the correct bezel must be installed to ensure proper air flow.

 

Service Reference Guide, dx7300

433611-001

6–17