Removal and Replacement Procedures— Microtower (MT) Chassis
6.9.3Installing a Drive
ÄCAUTION: To prevent loss of work and damage to the computer or drive:
■If you are inserting or removing a hard drive, shut down the operating system properly, then turn off the computer. Do not remove a hard drive while the computer is on or in standby mode.
■Before handling a drive, ensure that you are discharged of static electricity. While handling a drive, avoid touching the connector. Refer to Section 5.2, “Electrostatic Discharge Information” for more information about preventing electrostatic damage.
■Handle a drive carefully; do not drop it.
■Do not use excessive force when inserting a drive.
■Avoid exposing a hard drive to liquids, temperature extremes, or products that have magnetic fields such as monitors or speakers.
1.Install four guide screws (two on each side) into the new drive. The screws help guide the drive into its proper position in the bay.
❏If this is a new installation, guide screws are provided on the front of the chassis under the front bezel.
❏If this is a replacement drive, use the screws removed from the old drive.
✎There are a total of eight extra guide screws on the front of the chassis. Four have U.S. threads and four have metric threads. Metric screws have a black finish. U.S. threaded screws have a silver finish. Make sure to install the appropriate guide screws into the drive.
2.Align the guide screws with the guide slots, then slide the drive into the drive bay, making sure it is fully seated.
| Service Reference Guide, dx7300 |