Large, black typefaces look splotchy (not smooth)

The default enhancement setting might not be suitable for the job. Check the setting and change it to enhance text or photographs, if needed. For more information, see Change copy settings.

Horizontal grainy or white bands in light-gray to medium-gray areas

The default enhancement setting might not be suitable for the job. Check the setting and change it to enhance text or photographs, if needed. For more information, see Change copy settings.

The device prints half a page, then ejects the paper

Check the ink cartridges

Make sure the correct ink cartridges are installed and the ink cartridges are not low on ink. For more information, see Device management tools and Check the estimated ink levels.

HP cannot guarantee the quality of non-HP ink cartridges.

Paper mismatch

Check the settings

Verify that the loaded media size and type matches the control panel settings.

Solve scan problems

If the following topics do not help, see HP support for information about HP support.

NOTE: If you are starting the scan from a computer, see the software Help for troubleshooting information.

Scanner did nothing

Scan takes too long

Part of the document did not scan or text is missing

Text cannot be edited

Error messages appear

Scanned image quality is poor

Scan defects are apparent

Scanner did nothing

Check the original

Make sure that the original is placed on the scanner glass correctly. For more information, see Load an original on the scanner glass.

Check the device

The device might be coming out of PowerSave mode after a period of inactivity, which delays processing a short while. Wait until the device reaches the READY state.

Check the software

Make sure the software is properly installed.

Solve scan problems

95