HP Remote Graphics 4.2.0 User's Guide
Setup Mode hotkey | The Setup Mode hotkey sequence specified using a | |
sequence is invalid. | property either on the | |
The sequence has | configuration file, or RGS Enterprise Service, is | |
been reset to the | invalid and has been reset to the default. | |
default. |
| |
|
| |
Setup Mode hotkey | The Setup Mode hotkey sequence specified using a | |
sequence is invalid. | property either on the | |
The sequence has | configuration file, or RGS Enterprise Service, is | |
been disabled. | invalid and the property | |
| Rgreceiver.Hotkeys.IsMutable is disabled. Therefore | |
| hotkeys have been disabled. | |
|
| |
Connection denied! | The iLO remote console is enabled on the HP Blade | |
The iLO remote | Workstation. The Blade must be configured in User | |
console is enabled. | Mode before connections are allowed. | |
|
| |
Unable to connect | This is usually indicative of a DNS error. | |
to Sender: |
| |
The Receiver was |
| |
unable to resolve |
| |
the specified |
| |
hostname or IP |
| |
Address. Verify |
| |
that you entered |
| |
the value correctly. |
| |
|
| |
Unable to connect | The Receiver was able to lookup and resolve the | |
to Sender: | specified hostname or IP address. However, the | |
The Receiver | Receiver was unable to establish a connection to the | |
Sender. There are several possibilities such as the | ||
resolved the | ||
Sender is not installed, the Sender is not running, the | ||
specified hostname | ||
Sender is listening on the wrong network interface, or | ||
or IP address, but | ||
a firewall is blocking the Sender. | ||
cannot connect to | ||
| ||
the Sender. Verify |
| |
that the system is |
| |
accessible on your |
| |
network and that |
| |
the Remote |
| |
Graphics Sender |
| |
service has been |
| |
started and is |
| |
listening on a pubic |
| |
IP address and is |
| |
not blocked by a |
| |
firewall. |
| |
|
|
142