Using Remote Graphics Software

Rgreceiver.Usb.IsEnabled=bool

If set to "1", remote USB will be enabled. If set to "0", all remote USB will be disabled and no network bandwidth will be consumed for remote USB.

This property only applies to HP Blade Workstation Client.

Rgreceiver.Usb.ActiveSession=int

When the RGS Receiver is in Directory Mode or Enterprise Service Mode, the Receiver can connect to one or more RGS Senders. This property will specify the RGS Sender that remote USB will be connected to. To have all remote USB go to the first sender, use value zero. To have all remote USB go to the second sender, use value one, and so on. Remote USB can only go to one sender at a time. To change the sender, all senders must be disconnected. Then, enter a new value and reconnect all senders. The default value is zero - the first sender to be connected.

This property only applies to HP Blade Workstation Client.

RGS Sender Properties

All of the following properties are used by the RGS Sender, and can be set from the command line or from the RGS Sender property configuration file (rgsenderconfig).

General Properties:

Rgsender.IsRdpLogoutDetected=bool

The methods provided by Microsoft to close a connection through Remote Desktop Protocol (RDP) work quickly when the user disconnects from the RDP session. If the user logs out of the RDP session, the RGS Sender will be unable to access the desktop for about 60 seconds. If set to "1", the desktop will be available to the user through RGS as soon as possible. The RGS Sender will monitor the RDP session for a logout and begin the process of making the desktop available as soon as the logout is detected. If set to "0", the RGS Sender will not monitor the RDP session for a logout.

This property only applies to Windows versions of the RGS Sender.

Rgsender.IsCopyRegionEnabled=bool

If set to "1", RGS Copy Regions are sent from the Sender to the Receiver. If set to "0", RGS Copy Regions are turned off and will be sent to the Receiver as Image Update Regions. This is for advanced use and should not be set. The default value is "1" - send RGS Copy Regions.

Rgsender.IsRegionLimitEnabled=bool

Used to limit the number of update rectangles in a update region. This is for advanced use and should not be set. The default value is 0 - don't limit regions.

81