Configuring a Point-to-Point Node

Configure Node Mapping

Step 7. Enter information for non-adjacent (remote) nodes in the same manner in the fields provided. (You do not configure a phone number or security string for non-adjacent nodes.)

Step 8. Press the [Save Data] key to save the data on the screen. Proceed to Chapter 10 , “Validating and Cross-Validating with SYSGEN,” and press the [Validate Netxport] key.

Figure 7-7 Using an @ for Mapping Non-Adjacent Nodes

Priority

Number from 1 to 99 that indicates which route has precedence (priority) over another when there are multiple routes to a destination. A route to a destination that has a higher priority will take precedence over a route with a lower priority.

Disable Route

Y (yes) or N (no) indicator that allows you to temporarily disable a configured route. Leave the default (N) alone if you do not want to disable the route.

Phone Number

Required if the link is a dial link. The field must be blank if the target node is non-adjacent. Enter the telephone number as a combination of decimal numbers (0 through 9), dashes, and the following special characters:

/

Separator used for automatic call units

 

that have second dial-tone detect.

E

Optional end-of-number indicator.

D

Three-second delay (used for European

 

modems and automatic call units that

 

require built-in delays).

#

Defined by local phone system.

*

Defined by local phone system.

Chapter 7

123