Configuring a Gateway Half
Configure a Gatehalf Network Interface
Configure a Gatehalf Network Interface
The Gatehalf Configuration screen (#40) in Figure
Figure
Step 1. In the Partner’s IP address field, enter the internet protocol (IP) address of this gateway half’s partner.
Step 2. The IP subnet mask is optional. If entering one, tab down to the next field. In the IP subnet mask field, enter the number in the same format as an IP address.
Step 3. Tab to the Home NI name field. Enter a name that is the same as one of the other network interface names of the node being configured (except gatehalf or loopback networks).
Step 4. Tab down to the Link name field and enter a link name to represent each individual hardware interface card.
Step 5. Tab over to the Link type field. Enter DD for direct dial or DC for leased lines, private lines, or other
Step 6. Enter the physical path of this node’s Programmable Serial Interface (PSI) card.
142 | Chapter 9 |