Configuring a X.25 Node

Configure an X.25 Network Interface

Configure X.25 Virtual Circuits

The X.25 Virtual Circuit Configuration screen (#47) in Figure 8-3is displayed if you press the [Config Directry] key from the X.25 Configuration screen (#48) in Figure 8-2.This screen lets you configure the network directory.

Figure 8-3 X.25 Virtual Circuit Configuration Screen

Step 1. In the Remote node name field, type in the nodename of each remote X.25 node on your network in the format nodename.domain.organization. Also, if you need to be able to perform a loopback DSLINE command to the local node, then enter the local node’s name here as well.

Step 2. For each node, type the IP address of the node in the Remote IP address field.

Step 3. To specify that calls can be made to a node, enter its address key in the Address key field. Enter the node portion of the remote node’s configured nodename.

Chapter 8

131