Configuring a LAN Node
Configure a Token Ring Network Interface
Configure a Token Ring Network Interface
The Token Ring Configuration screen (#49) in Figure
Figure
Step 1. In the IP address field, enter the internet protocol (IP) address for the
| node being configured. An example of an address is |
| C 192.191.191 009. |
Step 2. | The IP subnet mask is optional. If entering one, tab to the IP subnet |
| mask field and enter the number in the same format as an IP address. |
Step 3. | Move to the Link name field. Enter a link name to represent the Token |
| Ring card for which you are configuring a link. This name must be |
| unique to the node. |
Step 4. | Tab down to the field called Physical Path of Token Ring Device |
| Adapter. Enter the physical path number corresponding to the SPU |
| slot number where the Token Ring device adapter is located. |
| If the same Token Ring card is being used for both NS and SNA |
NOTE | |
| communications, you must use the same value for this field as is |
| configured for the SNA Link. |
96 | Chapter 6 |