HP E3000 MPE/IX, E3000/IX Configuring a Point-to-Point, Node

7	Configuring a Point-to-Point
	Node
	This chapter provides step-by-step instructions for configuring
	Point-to-Point links. (Point-to-Point links are sometimes referred to as
	router links.) This manual assumes that you are using the guided
	configuration capabilities of NMMGR.
	Figure 7-1shows the screen flow for configuring Point-to-Point screens.
	Screens unique to Point-to-Point configuration are indicated by bold
	boxed screens. [FUNCTION] denotes the function key used at a screen to
	invoke the next screen on the screen flow.
Figure 7-1	Point-to-Point Link Configuration Screen Flow
		Open Config/
		Directory File Screen
		[OPEN CONFIG]

Main Screen

[NS]

NS Config

If you have not created the config file, then press the OPEN CONFIG key a second time.

								[GUIDED CONFIG]
						Network Transport
							Config
								[CONFIG NETWORK]
						Point-to-Point Link
[LINK ROUTING]							Config
		(TYPE SD)			[LINK ROUTING]			[NEIGHBOR GATEWAY]
					(TYPE DD or DC)
	Shared Dial Node			Direct Connect/Dial			Neighbor Gateways
		Mapping Config	Node Mapping Config
								[ADD or MODIFY]
							Neighbor Gateway
		[VALIDATE NETXPORT]					Reachable Networks
		Validate Link,
		Cross-validate
		with SYSGEN

107