Chapter 9

Clean the sensor

NOTE: This procedure is only necessary when you see an error message relating to the ink cartridges. For more information about error messages, see Errors.

Clean the sensor.

If the problem is not resolved, printing can continue, but the ink system behavior might change.

CAUTION: The cleaning procedure should take only a few minutes. Make sure that the ink cartridges are reinstalled in the product when instructed. Leaving them outside of the product for an extended period of time can result in damage to the ink cartridges.

To clean the sensor in the product

1.Gather swabs or a lint-free cloth to use for the cleaning procedure.

2.Make sure the product is turned on.

3.Open the ink cartridge access door by lifting from the front right of the product, until the door locks into place.

The print carriage moves to the center of the product.

NOTE: Wait until the print carriage stops moving before proceeding.

148 Maintain and troubleshoot

Page 152
Image 152
HP E709, 6500 manual Clean the sensor, To clean the sensor in the product