0 39 
%
1Make sure the digital sender is idle.
2At the control panel, press SETUP (ALT+F4). Then press SETTINGS (F2).
3Select any of the configuration menus. If an administrator password is required, the HP Digital Sender 8100C Administrator’s Password dialog box appears. Type the password and press OK (F1).
4When the configuration menu appears, press TOOLS (F2).
5Select Factory defaults and press OK (F1).
6Press OK (F1) to confirm that you want to reset to factory defaults.
'
At any time, you can check the database of address books to correct problems and inconsistencies in the information.
Perform the database check for the following reasons:
●when the digital sender seems to be performing slowly for no apparent reason
●when the digital sender was inadvertently turned off during a sensitive operation (such as saving configuration changes)
●when you detect inconsistencies between address books and distribution lists
●when instructed to do so by troubleshooting steps or by HPcustomer support Notes about the procedure:
●The procedure causes the digital sender to shut down and then restart.
●The procedure can take as long as 25 minutes, based on the amount of information in address books.
Note | If the check fails, turn the digital sender off and back on, and then try again. If the problem |
| persists, the address book database is beyond recovery. Clear the address book database |
| (see pag e40). |
|
|
