HP GbE2c cur, nbr, key, cur, key, cur, dead, none, none, Table, hello, trans, retra, mdkey, NOTE:, delete, aindex, enable, delete, enable, delete, disable, disable

Table 137	OSPF Interface Configuration Menu options
Command	Description
disable	Disables the OSPF interface.
delete	Deletes the OSPF interface.
cur	Displays the current settings for OSPF interface.

OSPF Virtual Link configuration

Command: /cfg/l3/ospf/virt <1-3>

[OSPF Virtual	Link 1 Menu]
aindex	- Set area index
hello	- Set hello interval in seconds
dead	- Set dead interval in seconds
trans	- Set transit delay in seconds
retra	- Set retransmit interval in seconds
nbr	- Set router ID of virtual neighbor
key	- Set authentication key
mdkey	- Set MD5 key ID
enable	- Enable interface
disable	- Disable interface
delete	- Delete interface
cur	- Display current OSPF interface configuration

NOTE: This menu is available only on the GbE2c Layer 2/3 Ethernet Blade Switch.

The following table describes the OSPF Virtual Link Configuration Menu options.Table 138 OSPF Virtual Link Configuration Menu options

Command	Description
aindex <0-2>	Configures the OSPF area index.
hello <1-65535>	Configures the authentication parameters of a hello packet, which is set
	to be in an interval of seconds.
dead <1-65535>	Configures the health parameters of a hello packet, which is set to be in
	an interval of seconds. Default is 40 seconds.
trans <1-3600>	Configures the delay in transit in seconds. Default is one second.
retra <1-3600>	Configures the retransmit interval in seconds. Default is five seconds.
nbr <IP address>	Configures the router ID of the virtual neighbor. Default is 0.0.0.0
key <password>	Configures the password (up to eight characters) for each virtual link.
	Default is none.
mdkey <1-255>none	Sets MD5 key ID for each virtual link. Default is none.
enable	Enables OSPF virtual link.
disable	Disables OSPF virtual link.
delete	Deletes OSPF virtual link.
cur	Displays the current OSPF virtual link settings.

Configuration Menu 134