RW
Queues, with wait, a local HP 1000 program.
RW,program[,parameters]
program | Name of the program to be scheduled. The program must have |
| an ID segment and be loaded as a system utility. |
parameters | Up to five parameters or a string to be passed to the program. |
| If the first parameter is not provided, it is set to the value |
| returned by LOGLU. If the fifth parameter is not provided, it is |
| set to the negative session number obtained if RMOTE |
| successfully establishes a session. |
SV
Sets or changes the severity code.
SV,severity |
|
|
severity | Severity may be: |
|
| 0 | Display error codes and echo commands on |
|
| log device (default). |
| 1 | Inhibit command echo on log device. |
| 2 | Command echoed only if RMOTE error |
|
| occurred. |
SW
Establishes which HP 3000 a HELLO will be sent and toggles between the HP 3000 and HP 1000.
[,lu]
SW ,#x.25address[,x.25lu]
lu | The positive LU number of a BISYNC link to an HP 3000. If |
| this parameter is omitted, the first BISYNC HP 3000 LU |
| specified at NSARPA initialization is used. |
x.25address | The X.25 network address assigned to the HP 3000. The pound |
| sign (#) must appear before the address. The address can |
| consist of up to fifteen digits. There is no default X.25 network |
| address. |
x.25lu | Specifies the physical X.25 link to use. Only necessary when |
| more than one X.25 I/O board is in use. This is not the virtual |
| circuit LU but is the network LU as defined by XINIT, the X.25 |
| initializationprogram. |
94 REMOTE