Resetting the Camera
If your camera does not respond when you press any buttons, try resetting the camera as follows:
1Holding the camera upside down with the front of the camera facing you, open the Battery/Memory card door on the bottom of the camera.
2If you have an optional memory card installed, remove it. (Although removing an optional memory card is not necessary for performing the reset, it eliminates the memory card as a possible cause of the problem.)
3Remove the battery from the camera, and make sure the HP AC power adapter is not connected to the camera.
4The Reset switch is the small hole located above the battery slot, as shown. Press the straightened end of a paper clip into the Reset switch until the switch is depressed, and hold it down for approximately five seconds, then remove
the paper clip. The camera is now reset.
5Reinsert the battery and the optional memory card (if you have one) and close the Battery/Memory card door. You may now use the camera again.
112 | HP Photosmart R507/R607 User’s Manual |