Installing the Battery
Your camera uses a rechargeable HP Photosmart R07 lithium ion battery (L1812A).
NOTE The battery that was shipped with your camera is partially charged, but you should fully charge it before using it the first time. You can charge the battery while it is in the camera. See Charging the Battery on page 16.
1If the Battery/Memory card door is already open, skip this step and go on to step 2.
Hold the camera with the bottom facing up, as shown, and slide the Battery/ Memory card door latch to open the Battery/Memory card door.
2Insert the battery in the larger slot as shown, and push it in until the latch catches.
3Close the Battery/Memory card door on the bottom of the camera by pushing the door down until it snaps closed.
To remove the battery from the camera, first turn the camera off. Then open the Battery/Memory card door, release the battery latch, tilt the camera, and the battery will slide out of its slot.
14 | HP Photosmart R507/R607 User’s Manual |