FRU information (service only) 123
3. Remove the left- side cover (see “Removing the side
cover” on page 4 4.
4. Turn the ser ver onto its right sid e so that the open left
side is facing up.
Note: Rotate the feet in toward the server so they do
not detach due to the weight of the server.
5. Remove the bezel assembly (see “Bezel assembly” on
page 114).
6. Remove the main bezel (s ee “Main bezel” on page
115).
7. Remove the support b racket (see “R emoving th e sup-
port bracket” on page 45) and air baffle.
8. Remo ve all ad apt e r car ds ( s ee “W orki ng wi th ad ap ter s”
on page 45).
9. Detac h cables from the system board.
10. Remove the hard disk drive cage (see “Installing a hard
disk driv e in bays E, F, or G” on page 53).
11. Using side cutters, sever the four r ubber extensions o n
the outside of the server.
12. Pull the fan away from and out of the server.
13. To install the new fan assembly, place the fan in posi-
tion in the server.
14. Guide the rub ber extensions through the apertures.
15. Use needle-nosed pliers to pull the extensions through
the apertures.
16. Reconnect cab les.

Floppy disk drive

Before you begin:
• Read “Saf ety inf ormation” on page 155.
• Review the in formation in “Before you begin” on page
43.
Note: This illustration depic ts the server in the upr ight posi-
tion. It is recommen ded tha t the server be placed on
its left side before performing this service procedure.