58 Net finity 3500 -M20 – T ype 8657 Mod els 21 Y, 2 2Y, 31Y, 32Y ,
face on the server; then, re move t he microproces-
sor from the package.
b. Orient the microprocessor over the microproces-
sor connector as shown in the following illus tra-
tion. Carefully press the microprocessor into the
connector.
Þ1Ý Microprocessor 2 connector
Þ2Ý Lever
Þ3Ý Microprocessor orientation indicator
Þ4Ý Microprocessor 2
Þ5Ý Termin ator card
Note: Do no t use excessive force when pressi ng th e
microprocessor int o the connector.
6. Push t he r e le ase le ver do w n to l oc k t h e m icr op roce sso r
into place.
7. Insta ll th e heat sink on the microprocessor:
a. Peel the plastic protective strip off the bottom of
the heat sink. Make sure the square of thermal
material is still on the bottom of the heat sink.
b. Align and place the heat sink on top of the micro-
processor.
c. Align and place the clip over the heat sink, then
sna p it in to place.
8. Place the terminator card in the static-protectiv e pack-
age that the new microprocessor was shipped in, and
store it in a safe place. You will need to install the ter-
minator card again if you ever remove the microproces-
sor and do not replace it wi th another micropro cessor.