IBM 21Y, 22Y, 31Y, 32Y, 41Y, 42Y Using the SCSISelect utility program, Starting the SCSISelect utility program, Choices available from the S CSISelect menu

Configuring the server 37

The keyboard and mouse rema in locked until you enter the

correct password.

You can use any combination of up to seven characters (A–

Z, a–z, and 0–9) for the power-on password. Keep a record

of the password in a secure place. If you for get the power-

on password, you can regain access to the se rver through

one of the following m ethods:

• Start t he Configuration Setup Utility program and

change the power-on passw ord.

• Cha nge t h e p osit io n of t he pass w ord ove rr ide swit ch a s

described in “Setting the password override switch”.

• Remove the bat tery and then install the batter y.

Setting the password override switch:

When a

power-on password is set, POST does not complete until

you ente r the password. If you forget th e power -on pass-

word, you can regain access to the server by changing the

position of switch 8 on th e system board to bypass the

power-on passw ord check. You can then start the Configu-

ration/ Setup Utility program and change the power-on pass-

word. For the location of the password override switch, see

Table 6 on page 43.

Using the SCSISelect utility program

SCSISelect is a built-in, menu-driven configuration utility

program that you can use to:

• View the default SCSI IDs

• Locate and correct configuration conflicts

Note: If the server has a RAID adapter installed, use the

configuration method supplied wit h the RAID adapter

to view or change SCSI settings for attached devices.

Starting the SCSISelect utility program

To start the SCSISelect utility program:

1. Turn on the server.

2. When the <<< Press <CTRL><A> for SCSISelect™

Utility! >>> prompt appears, press C trl+A.

3. When the Would you like to configure the host

adapter or run the SCSI disk utility? question

appears, make your selection and press Enter.

4. Use the arrow keys to select a choice from the menu.

• Press Esc to return to the previous menu.

• Press the F5 key to switch between color and

monochrome modes (if the monitor permits).

5. Follow the instruct ions on the s c reen to change the set-

tings of the selected items; then, press Enter.

IBM Using the SCSISelect utility program, Starting the SCSISelect utility program, Choices available from the S CSISelect menu

Models: 21Y 22Y 31Y 32Y 41Y 42Y

Setting the password override switch:

Using the SCSISelect utility program

Starting the SCSISelect utility program

Choices available from the S CSISelect

menu