IBM 4400 Fileio Runfile, Maxsize, Minsize, Font, Ifont, Engine Almwide, Almnarrow, Almenable

Appendix B The PTR_SETUP Commands

Table 80. PTR_SETUP Commands (continued)

Command	Sub-Command	Parameter	Description
FILE_IO	RUNFILE	File;Prop	The RUNFILE command will open
(DISK_IO)			the file named File for printing. After
			the PTR_END command is
			processed, the contents of File will
			get printed before any more data is
			read from the host. If the Prop field
			is present, RUNFILE will verify that
			Prop matches the saved file
			properties. Any mismatch will cause
			the command to be ignored.
	MAXSIZE	Kb	For backwards compatibility.
	MINSIZE	Kb	For backwards compatibility.
	FONT	FontName	Downloads an HP** LaserJet** font
			and saves it as FontName.
	IFONT	FontName	Downloads a scalable AGFA type
			font and saves it as FontName.
ENGINE	ALM_WIDE	wide width	Set the Auto Label Mapping wide
			width (in units of 1/1000”; e.g., a
			wide width value of 1000 = 1”),
			which represents the width of the
			image in the file sent from the host
			which is to be auto label mapped
			into several labels, each of which
			will have a width of narrow width.
			# of labels=wide width/narrow width
			(rounded down)
	ALM_NARROW	narrow width	Set the Auto Label Mapping narrow
			width, which represents the width of
			one auto mapped label (in units of
			1/1000”; e.g., a narrow width value
			of 1000 = 1”). This width should be
			set prior to the wide width. In
			addition, it can never exceed the
			physical width of the printer. If it
			does, the narrow width will be
			automatically reduced to the Page
			Width value set in the configuration
			menu.
	ALM_ENABLE	N/W/*	Set Auto Label Mapping to Narrow,
			Wide, or Off. Enter N for Narrow, W
			for Wide, or any other letter to
			disable ALM. By default, only the
			Narrow option is implemented.

286