IBM 4400 manual Engine Imageshfth, Imageshftv, Length, Mediahandling, Mode, Width, Ptrend

Commands

Table 80. PTR_SETUP Commands (continued)

Command	Sub-Command	Parameter		Description
ENGINE	IMAGE_SHFT_H	Value	Shifts the image Value horizontally
			in 1/1000” units. If Value is out of the
			settable range (-1” to +1”), the
			command will be ignored.
	IMAGE_SHFT_V	Value	Shifts the image Value vertically in
			1/1000” units. If Value is out of the
			settable range (-1” to +6”), the
			command will be ignored.
	LENGTH	Value	Sets the Page Length (in 1/1000”
			units).
	MEDIA_HANDLING	Value	Sets the type of media handling:
			0	- Continuous
			1	- Tear-Off Strip
			2	- Tear-Off
			3	- Peel-Off
			4	- Cut
	MODE	X	Sets the print mode to Thermal
			Transfer.
		D	Sets the print mode to Direct
			Thermal.
	WIDTH	Value	Sets the Page Width (in 1/1000”
			units).
PTR_END	(none)	(none)	Exits the PTR_SETUP.

Summary of the CONFIG Command

The UPLOAD and DOWNLOAD command can be used for uploading and downloading complete printer configurations. If a customer needs to configure 50 printers identically, the customer needs only configure one printer and UPLOAD the configurations. The UPLOADed configurations may then be DOWNLOADed to other printers eliminating the necessity for the operator to configure each printer manually.

The UPLOAD command will always place a header and a footer into the uploaded data. This header will be the DOWNLOAD command followed by the configuration number. The footer will be the DOWNLOAD END command. The operator should be aware that the UPLOAD and DOWNLOAD commands use a secondary copy of the menu structure which does not affect the printer's active configuration. This allows the UPLOAD and DOWNLOAD commands to operate without affecting the printer's current configuration. If the operator intends to use one of the DOWNLOADed configurations, the operator should reboot the printer to ensure proper operation. This can be accomplished by adding the RESET command as the last command in your setup file. This is necessary because the printer caches the active

287