Table 36. | Logic Analyzer Pod 6 |
|
|
|
|
|
|
| Logic Analyzer Channel Number | ||
|
|
|
|
| 5 | CLK/16 | Unused |
|
|
|
|
| 7 | 15 | AD63 |
|
|
|
|
| 9 | 14 | AD62 |
|
|
|
|
| 11 | 13 | AD60 |
|
|
|
|
| 13 | 12 | AD59 |
|
|
|
|
| 15 | 11 | AD58 |
|
|
|
|
| 17 | 10 | AD57 |
|
|
|
|
| 19 | 9 | AD56 |
|
|
|
|
| 21 | 8 | AD55 |
|
|
|
|
| 23 | 7 | AD54 |
|
|
|
|
| 25 | 6 | AD53 |
|
|
|
|
| 27 | 5 | AD52 |
|
|
|
|
| 29 | 4 | AD51 |
|
|
|
|
| 31 | 3 | AD50 |
|
|
|
|
| 33 | 2 | AD49 |
|
|
|
|
| 35 | 1 | AD48 |
|
|
|
|
| 37 | 0 | AD48 |
|
|
|
|
The recommended placement of the mictor connectors is at either end of the bus segment. The mictors are placed at the end of, as short a stub as possible, daisy chained off either end of the bus. When there is not enough room to place the mictors 0.5 inches from the target, then an alternate method may be used. That is, to place the logic analyzer termination circuitry on the target and then extend the etch from the end of the termination circuitry over to the mictor connectors. The connection from the mictors to the logic analyzer must then be done with the E5351A. The E5346A contains the logic analyzer termination circuitry, the E5351A does not.
Design Guide | 73 |
