Intel A31032-001 manual Remote Telnet Sessions, Local Serial Console

C H A P T E R 6 Intel® NetStructure™ 7110/7115 e-Commerce Accelerator User Guide

NOTE: To ensure that this remote management configuration persists across a device shutdown and startup, run the config save command.

Remote Telnet Sessions

This section contains procedures for accessing the 7110/7115’s CLI via remote Telnet session.

Local Serial Console

Assign an IP address to the 7110/7115’s network interface using the following procedure:

Intel 7115> set ip

Enter IP [10.1.2.56]: 10.1.1.1

Enter Netmask [255.255.255.0]:

Verify the IP and netmask (optional):

Intel 7115> show ip

System IP Address : None

System Netmask	: None
Intel 7115>

Enable remote Telnet sessions:

Intel 7115> set telnet enable

Configure the network route:

Intel 7115> set route

Enter Default Route (’none’ to delete) [10.1.1.1] : <enter>

Verify the route configuration (optional):

Intel 7115> show route

Default Route : 10.1.1.1

Delete a route configuration (optional):

Intel 7115> set route none

Remote Telnet management is now enabled and configured on the 7110/7115. Now you can access the CLI from a remote Telnet session.

6-4