Intel MPCBL0001 manual Digital Ground to Chassis Ground Connectivity, J40 Jumper Assignments

Intel NetStructure® MPCBL0001 High Performance Single Board Computer

Contents

Table 101.	J40 Jumper Assignments
	Jumper	Function
	J40-1 to 2	Boot block unprotected.
	J40-2 to 3	IPMC Boot block has been protected (Default). If user
		were to update the IPMC boot block, the jumper needs
		to be connected to 1-2.

NOTE: This jumper is only applicable to the following versions of MPCBL0001 boards:

•MPCBL0001F04 - TA# (or above) C55360-014

•MPCBL0001N04 - TA# (or above) C13354-013

•MPCBL0001F04Q - TA# D17324-003

•MPCBL0001N04Q - TA# D18530-003

10.5Digital Ground to Chassis Ground Connectivity

In the default grounding for the MPCBL0001xxx, digital ground is isolated from the chassis ground.

To connect the digital ground to the chassis ground, follow this procedure:

1.Remove the screw with the black insulation washer (circled in red in Figure 28 below).

2.Remove the black insulation washer and store it in a safe place. It will be needed if you want to isolate the digital ground from chassis ground in the future.

3.Reinstall the screw and tighten to 4 lb-in.

Note: Digital ground is also called logic ground. Chassis ground is also known as shelf ground.

Technical Product Specification	149
Order #273817