Intel SEL Events Supported by the MPCBL0001 SBC Sheet 1, Sensor, Event Remarks Type Type Code

Intel NetStructure® MPCBL0001 High Performance Single Board Computer

Contents

Table 3.	SEL Events Supported by the MPCBL0001 SBC (Sheet 1 of 4)
Sensor	Sensor	Sensor-Specific
		Offset (Event	Event	Remarks
Type	Type Code
		Data 1, Bit 0-3)
Reserved	00h	-	Reserved	-
Temperature	01h	-	Temperature	Threshold exceeded for upper critical, upper non-
				critical, lower critical and lower non-critical
				thresholds. Refer to Table 4, “Sensor Thresholds for
				IPMC Firmware 1.0” on page 37 for sensor
				thresholds data.
Voltage	02h	-	Voltage	Voltage exceeded upper critical, upper non-critical,
				lower critical and lower non-critical thresholds. Refer
				to Table 4 for sensor thresholds data.
Processor	07h	00h	IERR	Processor IERR has occurred.
		01h	Thermal Trip	Processor thermal trip has occurred.
		04h	FRB3/Processor Startup/	An FRB3 Timer (30 seconds) was implemented to
			Initialization Failure	detect the failure of the CPUs from booting.
			(CPU did not start)	Event data 3 = Last Post 80 code byte
		05h	Configuration Error	CPU 0 and CPU 1 are not present.
		07h	Processor Presence
			Detected1
		09h	Terminator Presence
			Detected1
Power Unit	01h	00h	Power Off/Power On	Normal power off indication. Offset 0 is just a status
				indicating that the payload power is off. It does not
				generate an event when it is set. (For internal use).
		05h	Soft Power Control	The Power Unit sensor is used to detect when the
			Failure (unit did not	Payload power does not come up when the board is
			respond to request to	told to power on.
			turn on)	When the board enters M4 state, the IPMC asserts a
				Power Enable line to cause the Payload to power up.
				The IPMC then waits for another line that indicates
				that the power has come up successfully. If that line
				does not assert within 2 seconds, then offset 05h is
				asserted on the Power Unit sensor, which generates
				an event to notify the Shelf Manager of the failure.
Memory	0Ch	00h	Correctable ECC	Event data 3 = DIMM pair number
				00 refers to J8/J9
				01 refers to J10/J11
		01h	Uncorrectable ECC	Event data 3 = DIMM pair number
				00 refers to J8/J9
				01 refers to J10/J11
NOTE:

1.These sensor offsets do not generate events, but they are valid offsets when reading the sensor values.

2.Watchdog sensor refers to WDT#1 per Section 3.13.1.

Technical Product Specification	33
Order #273817