Intel MPCBL0001 manual PMC Connectors J25, J26, J27, Fibre Channel SFP Pin Assignments

Intel NetStructure® MPCBL0001 High Performance Single Board Computer

Contents

Table 50.	Fibre Channel SFP Pin Assignments
	USFibre Channel Connector (J34, J35) Pin		Fibre Channel SFP Optical Transceiver Module
		Assignments	(J34, J35)
		Fibre Channel CONNECTOR
	Pin #	Signal Name
	1	Transmitter Ground
	2	Transmitter Fault (not supported)
	3	Transmitter disable
	4	Module Definition 2
	5	Module Definition 1
	6	Module Definition 0
	7	Rate Select
	8	Loss of Signal Indication
	9	Receiver Ground
	10	Receiver Ground
	11	Receiver Ground
	12	Receiver Inverted DATA Out
	13	Receiver Non-Inverted DATA Out
	14	Receiver Ground
	15	Receiver Power Supply
	16	Transmitter Power Supply
	17	Transmitter Ground
	18	Transmitter Non-Inverted DATA In
	19	Transmitter Inverted DATA In

20Transmitter Ground

4.2.5PMC Connectors (J25, J26, J27)

There are three 64-pin connectors that make up the PMC card connection:

MOLEX Part Number: 71439-0864

These connectors and pinouts are defined by the following industry standard specifications:

•Draft Standard Physical and Environmental Layers for PCI Mezzanine Cards: PMC IEEE (MMSC) P1386.1/Draft 2.3, October 9, 2000

•Draft Standard for a Common Mezzanine Card Family: CMC IEEE (MMSC) P1386/Draft 2.3, October 9, 2000

The PMC slot is available at the front panel. See Figure 13, “MPCBL0001 SBC Connector Locations” on page 80 for their positions on the board. Pin assignments are listed in Table 51, “PMC Connector Pin Assignments - 32 Bit” on page 92 and Table 52, “PMC Connector Pin Assignments - 64 Bit” on page 93.

Technical Product Specification	91
Order #273817