Intel MPCBL0001 manual 10.1

Intel NetStructure® MPCBL0001 High Performance Single Board Computer

Contents

3.4	E-Keying		46
3.5	IPMC Firmware Code		46
3.6	IPMC Firmware Upgrade Procedure		47
	3.6.1	IPMC Firmware Upgrade Using KCS Interface	47
	3.6.2	IPMC Firmware Upgrade via the IPMB Interface (RMCP)	48
		3.6.2.1 Updating MPCBL0001 Firmware	48
3.7	OEM IPMI Commands		48
	3.7.1	Reset BIOS Flash Type	49
	3.7.2	Set Fibre Channel Port Selection	49
	3.7.3	Get Fibre Channel Port Selection	49
	3.7.4	Get HW Fibre Channel Port Selection	50
	3.7.5	Set Control State	50
	3.7.6	Get Control State	52
	3.7.7	Get Port80 Data	52
3.8	Controls Identifier Table		52
3.9	Hot-Swap Process		53
	3.9.1	Hot-Swap LED (DS10)	54
	3.9.2	Ejector Mechanism	54
3.10	Interrupts and Error Reporting		55
	3.10.1	Device Interrupts	55
	3.10.2	Error Reporting	57
3.11	ACPI		58
	3.11.1	System States and Power States	58
3.12	Reset Types		58
	3.12.1	Reset Logic	59
	3.12.2	Hard Reset Request	59
	3.12.3	Soft Reset Request	59
	3.12.4	Warm Boot	60
	3.12.5	Cold Boot	61
	3.12.6	Power Good	61
3.13	Watchdog Timers (WDTs)		64
	3.13.1	WDT #1	64
	3.13.2	WDT #2	65
	3.13.3	WDT #3	65
3.14	LED Status		66
	3.14.1	Health LED	66
	3.14.2	OOS (Out Of Service) LED	66
	3.14.3	Hot-Swap LED	66
	3.14.4	IDE Drive Activity LED	67
	3.14.5	User Programmable LEDs	67
	3.14.6	Network Link/Speed LEDs	68
	3.14.7	Ethernet Controller Port State LEDs	68
	3.14.8	Fibre Channel Port State LEDs	69
	3.14.9	Setting the Default Color for the OOS and Health LEDs	69
3.15	FRU Payload Control		70
	3.15.1	Cold Reset	70
	3.15.2	Warm Reset	70
	3.15.3	Graceful Reboot	70
	3.15.4	Diagnostic Interrupt	71
3.16	Serial Port Buffering Overview		72
4		Technical Product Specification
			Order #273817