Intel MPCBL0001 manual Fibre Channel* U23 Optional

Intel NetStructure® MPCBL0001 High Performance Single Board Computer

Contents

•Supports advanced PCI commands such as MWI, MRM, and MRL, and PCI-X commands such as MRD, MRB, and MWB

•Full IEEE 802.3ab auto-negotiation of speed, duplex, and flow-control configuration

•Complete full duplex and half duplex support

•Automatic MDI crossover operation for 100Base-TX and 10Base-T modes

•Automatic polarity correction

•Digital implementation of adaptive equalizer and canceller for echo and crosstalk

2.2.4.5Fibre Channel* (U23) - Optional

The QLogic* ISP2312 dual Fibre Channel controller is used for access to high-speed storage subsystems. It is routed through backplane connector P23.

See Figure 20, “Component Layout (#1)” on page 100 for its location.

This controller supports PCI and PCI-X bus interfaces. Burst mode master DMA transfers are utilized for efficient usage of bus bandwidth during data transfers, and 8, 16, and 32-bit accesses are supported as a PCI target. The controller appears as two independent Fibre Channel ports. A PCI function is assigned to each port in the device’s PCI configuration space. Functions 0 and 1 are used to configure FC ports 1 and 2, respectively.

ISP2312 features include:

•32/64-bit 33/66 MHz, PCI Rev 2.2 compliant interface.

•Host interface compliant with the PCI-X addendum, Rev 1.0a, from 50 to 133 MHz.

•Supports 64-bit addressing (addresses >32 bit initiate use of DAC address cycle).

•Efficient PCI bus master operation, supported by optimized internal DMA controller.

•Supports advanced PCI commands such as MWI, MRM, and MRL, and PCI-X commands such as MRD, MRB, and MWB.

•Automatically negotiates Fibre Channel bit rate 1.06 Gbits/s (through backplane or front panel) or 2.12 Gbits/s (through front-panel Fibre Channel ports only)

•Supports up to 533 MBytes sustained FC data transfer rate (combined bandwidth of both directions transmitting simultaneously).

•Supports Fibre Channel-arbitrated loop (FC-AL), FC-AL-2, point-to-point, and switched fabric topologies.

•Maxim MAX3840 2x2 crosspoint switch for switching Fibre Channel between the front ports and the backplane, either via the BIOS Setup Menu by electronic keying.

•Each FC port includes:

—Internal RISC processor

—Receive DMA sequencer

—Frame buffer

—DMA channels (transmit, receive, command, auto-request, and auto-response)

24	Technical Product Specification
	Order #273817