Janome MB-4 manual Winding the Bobbin

z x		Winding the Bobbin
		z Place the thread cone (spool of thread) on the rear
q		most spool pin.
	w	Pass the thread through the thread guide A.
		q Thread guide A

x Pass the thread through the upper hole and lower hole in the thread guide B.

w Thread guide B

c	e
			c Draw the thread to the front.
			Hold the thread with both hands and pass the
	t		thread firmly around and under the tension disk.
			e Tension disk
	v	r	v Pass the thread through the hole in the bobbin
			from the inside.
			Put the bobbin on the bobbin winder spindle.
			r Hole in the bobbin
			t Bobbin winder spindle
b			b Push the bobbin winder stopper up against the
	n		bobbin.
			y Bobbin winder stopper
			n Press the bobbin winding button while holding the
	y		thread end.
	u		u Bobbin winder button
m			m Press the bobbin winder button to stop the
			machine when the bobbin has wound a few layers.
			Cut the thread close to the bobbin and press the
			bobbin winder button again.

,

, When the bobbin is fully wound, the machine will stop automatically.

.

Remove the bobbin from the bobbin winder spindle.

. Cut the thread with the bobbin thread cutter. i Bobbin thread cutter

i

16