JVC BR-DV6000U Rear panel, Video Line in terminal BNC, Video Y/C in terminal 4-PIN

NAMES AND FUNCTIONS OF PARTS

– Rear panel –

		1	6		7		! @
	LINE	VIDEO	COMPONENT				REMOTE2
	Y/C
2	IN		R-Y		B-Y	IN
			Y
3						OUT	AUDIO
							CH 1/3	CH 2/4
	OUT							IN
4
								OUT	$
	MONITOR		IN			OUT
	OUT			TIME CODE
			SYNC IN
				IN		OUT
						OFF
						REC	PLAY
	SIGNAL		DV		SERIAL	TIMER		MONITOR
		DC12V	IN/OUT					OUT	REMOTE1
	GND				REMOTE
		5	8	0	9		# %

1[VIDEO LINE IN] terminal (BNC)

This is the input terminal for composite video signals.

•To input video via this terminal, set the IN- PUT SELECT switch located on the front panel to “LINE”.

2[VIDEO Y/C IN] terminal (4-PIN)

This is the input terminal for YC separate video signals.

•To input video via this terminal, the following settings are required.

Set VIDEO INPUT SEL in the VIDEO Menu screen to “Y/C”.

Set the INPUT SELECT switch located on the front panel to “Y/C (CPN)”.

•When wide-screen ID signals are input, the wide-screen ID signal is recorded.

3[VIDEO LINE OUT] terminal (BNC)

This is the output terminal for composite video signals.

4[VIDEO Y/C OUT] terminal (4-PIN)

This is the output terminal for Y/C separate video signals.

•When tapes that have recorded wide-screen signals are played back, the wide-screen ID signal is output.

5[VIDEO MONITOR OUT] terminal

(BNC)

This terminal is for connecting to a monitor-TV.

•It outputs composite video signals.

•It displays the Menu setting screen, Date/ Time setting screen and warning information.

•If DISPLAY in the DISPLAY Menu screen is set to “ON” or “AUTO”, information will be dis-

played on-screen, e.g., the operation mode, date/time and counter. (☞ Page 20)

6[COMPONENT IN] terminal

(BNC3)

This is the input terminal for component video signals (Y/R-Y/B-Y). The signal level is high (ß cam spec).

•To input video of this terminal, the following settings are required.

Set VIDEO INPUT SEL in the VIDEO Menu screen to COMPONENT.

Set the INPUT SELECT switch located on the front panel to “Y/C (CPN)”.

7[COMPONENT OUT] terminal

(BNC3)

This is the output terminal for component video signals (Y/R-Y/B-Y). The signal level is high (ß cam spec).

Memo

Whether or not to enable SET UP for analog signals (composite, YC separate and compo- nent signals) can be selected with SET UP in the VIDEO Menu screen (for NTSC only).

16