JVC HM-HDS1U manual Display Counter Information, Display Tape Remaining Time, Exit the Display

RECORDING FEATURES for VHS deck EN 49

Recording Features

Display Elapsed Recording Time

1	RESET COUNTER TO ZERO
	Before recording starts, press C.RESET. The counter
	resets to zero and displays the exact elapsed time as the
	tape runs.
	DISPLAY ELAPSED TIME ON
	SCREEN
	During recording, press OSD at any time to see the
	elapsed time.
	All indications corresponding to the current status of the
2 recorder are displayed for 5 seconds. The counter
	display remains on the screen indicating the elapsed

1

2

1 2 3

4 5 6

7 8 9

< 0 >

C.RESET

1

2

3

4

OSD

time. Press OSD again to remove the display.

● Make sure “SUPERIMPOSE” is set to “ON“ ( pg.

41).

● The indications are not recorded.

● Press OSD to change to the COUNT display if

“REMAIN” is displayed.

Display Tape Remaining Time

(VHS deck only)

DISPLAY COUNTER

INFORMATION

–+

Record One Program While Watching Another

1	ENGAGE TV MODE
	During recording...
	● Change the TV's input mode from AV to TV.
	SELECT CHANNEL FOR
2	VIEWING
	Use the TV’s channel selector to set the channel you
	want to watch.

1 Press OSD.

All indications corresponding to the recorder’s current status are displayed for 5 seconds. The counter display remains on the screen indicating the elapsed time.

DISPLAY TAPE REMAINING TIME

2 Press OSD repeatedly until “REMAIN” appears on screen. The approximate tape remaining time appears on the TV screen and also on the recorder display panel with a "" indicator.

●The tape remaining time is calculated based on the tape speed (SP or EP) being used. The indicated remaining time is only an estimate.

●Press OSD to change the on-screen display from

“REMAIN” to “COUNT” and vice versa; and to show counter reading, channel number, clock time or tape remaining time on the front display panel. Then channel number will not be displayed when the recorder is playing a tape.

EXIT THE DISPLAY

3 Press OSD again.

NOTES:

●“SUPERIMPOSE” must be set to “ON”, or the on-screen display will not appear ( pg. 41).

●Near the beginning of the tape, the tape remaining estimate may be inaccurate. However, the estimate becomes more accurate as the tape comes closer to the end.

●Depending on the type of tape used, the tape remaining time reading may not appear right away, or may not be correct. "- -:- -" may sometimes appear, or the display may blink on occasion.

●The tape remaining time indication is not accurate when using VHS-C tapes with VHS-C adapter.