JVC PU30425 B.E.S.T. Picture System, Access Mode Select, Recording, Confirm B.E.S.T. Status

B.E.S.T. Picture System

6

q

RECORD

MODE

	2
1	2	3
4	5	6
7	8	9
	0
	PLAY

RECORD

3

1

PUSH JOG

21

The B.E.S.T. (Biconditional Equalised Signal Tracking) system checks the condition of the tape in use during recording and playback, and compensates to provide the highest-possible recording and playback pictures. The default setting for both recording and playback is “ON”.

Recording

1		LOAD A CASSETTE
		Insert a cassette with the record safety tab intact.
		● The recorder power comes on automatically.
		ACCESS MODE SELECT
2		SCREEN
		Press MODE. The On-
		Screen/B.E.S.T. screen	ON SCREEN	: ON
		appears.
			B.E.S.T.	: ON
			[5°]: SELECT
			[5]: ON/OFF
			[MODE] : EXIT
3		CONFIRM B.E.S.T. STATUS
		The default setting is “ON”. If this is the case, go to step
		4. If not, press PUSH JOG	to place the pointer next to
	Þ
	“B.E.S.T.”, then press PUSH JOG%to set to “ON”.
		CLOSE MODE SELECT
4		SCREEN
		Press MODE.
5		START RECORDING
		Press and hold RECORD and PLAY on the remote, or
	RECORD on the recorder.
		● The recorder spends approximately 7 seconds
		assessing the condition of the tape, then begins
		recording.
		● When the "BEST" indicator begins blinking, that
		means adjustment is complete.

Display Panel Indication

As the tape check progresses, the “– –” marks on the display panel increase upward. Once the "BEST" indicator starts blinking, the check is complete.