JVC PU30425 Activate Repeat, Repeat Playback, Next Function Memory, Tape Position Indicator

OPERATE

6

q

STOP	PLAY
.MEMORY
C

OPERATE

	2
1	2	3
4	5	6
7	8	9
	0
	PLAY	FF

REW

PAUSE

	3	STOP
1

15

Repeat Playback

Your video recorder can automatically play back the whole tape 20 times repeatedly.

1	START PLAYBACK
	Press PLAY.
	ACTIVATE REPEAT
2	PLAYBACK
	Press PLAY and hold for over 5 seconds, then release.
	● The Play indicator ( ) on the display panel blinks
	slowly.
	● The tape plays 20 times automatically, and then
	stops.
3	STOP PLAYBACK
	Press STOP at any time to stop playback.

NOTE:

Pressing PLAY, REW , FF or PAUSE also stops Repeat Playback.

Next Function Memory

You can set your recorder's power to go off automatically after the tape is fully rewound. Before starting, make sure the recorder is in the Stop mode.

For Automatic Power Off After Tape Rewind . . .

. . . press REW, then press OPERATE within 2 seconds.

NOTE:

If you want the power to be turned off automatically when the counter reads “0:00:00” (instead of at the beginning of the tape), press C.MEMORY so that the “M” mark appears before pressing REW.

Tape Position Indicator

The tape position indicator appears
on screen when, from the Stop
mode, you press FF, REW or
perform an Index Search. The
position of “5” in relation to “0”			3
(beginning) or “+” (end) shows you	0	+		+	+
where you are on the tape.					1:23:45
”On-Screen” (☞ pg. 23) must be				REMAIN 2:35

set to “ON”, or the indicator will not appear.

NOTE:

Depending on the type of tape used, there may be times when the indication is not correct.