JVC RX-9010VBK Basic Settings, Setting the Front Speakers Either for the, Main Room or Sub-room

MAIN ROOM SUB ROOM

Basic Settings

Some of the following settings are required after connecting and positioning your speakers, while others will make operations easier.

•You can use “On-screen Menu” for most of the main room operations. For details, see page 50.

The following operations are only possible while the receiver is ready for the main room operations.

IMPORTANT:

Check to see if the proper indicator(s) and information appear on the display on the front panel before/while using the buttons and controls.

For the main room operations:

On the front panel ONLY:

1. Press SETTING repeatedly until “FRONT SPK 2:” appears on the display.

SETTING

•The MAIN ROOM indicator is lit.

•The source name for the sub-room is not lit on the display.

The display changes to show the current setting.

2. Press CONTROL UP 5/DOWN ° CONTROL

• When using the remote control:

–Set MAIN ROOM/SUB ROOM selector to

“MAIN ROOM.”

– Check to see if the following information

appear on the display window on the remote control:

to specify the way you want to use the speakers connected to the

FRONT 2/SUB ROOM SPEAKERS terminals.

DOWN UP

MAIN ROOM/	Indications
SUB ROOM selector
MAIN ROOM	MAIN ROOM *
SUB ROOM	SUB ROOM *

	Buttons	Indications
	SOUND	SOUND
	After pressing SOUND, the following function are
	assigned to the specific number buttons:
	Buttons	Indications
	BALANCE L	SOUND
	BALANCE R
	SUBWFR	S WFR
Ex. When you press SOUND with				STANDBY	ON
		MAIN ROOM
MAIN ROOM/SUB ROOM			SUB ROOM		POWER
		ON/OFF	ON/OFF POWER
		MAIN ROOM	SUB ROOM TV/CATV/DBS		VCR1

selector set to “MAIN ROOM.”

MAIN ROOM SUB ROOM

When you set MAIN ROOM/SUB ROOM selector* and press the buttons listed above, the corresponding indication appears for 10 seconds for your confirmation.

Note:

*MAIN ROOM or SUB ROOM indicator does not appear when no indicators appear on the display window.

Setting the Front Speakers Either for the

Main Room or Sub-room

You can use the front speakers connected to the FRONT 2/SUB ROOM SPEAKERS terminals either as the 2nd front speakers for the main room or as the front speakers for the sub-room.

Before you start, remember...

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

•Each time you press the buttons, the display changes to show the following:

MAIN SUB

MAIN: Select this to use as the 2nd front speakers for the main room.

SUB: Select this to use as the front speakers for the sub- room.

Note:

You can also adjust the front speakers setting with “On-screen Menus” by using remote control. (See page 54.)

Adjusting the Front Speaker Output

Balance

If the sounds you hear from the front right and left speakers are unequal, you can adjust the speaker output balance.

• You can do this setting for each source.

Before you start, remember....

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

On the front panel:

LEVEL

1. Press LEVEL ADJUST repeatedly ADJUST until “BAL – (with current setting)” appears on the display.

2. Press CONTROL UP 5/DOWN °		CONTROL
to adjust the balance.		DOWN UP
•	Pressing CONTROL UP 5decreases the
	left channel output (from R –21 to
	CENTER, from CENTER to L –21).
•	Pressing CONTROL DOWN °decreases
	the right channel output (from L –21 to CENTER, from
	CENTER to R –21).

27