JVC RX-9010VBK manual Connecting the Speakers, AM Antenna Connections, Basic connecting procedure

AM Antenna Connections

	Snap the tabs on the loop into the
ANTENNA	slots of the base to assemble the
FM 75	AM loop.
COAXIAL

AM

LOOP

AM	AM Loop Antenna
EXT

123

Outdoor single vinyl-covered wire (not supplied)

Turn the loop until you have the best reception.

Notes:

• If the AM loop antenna wire is covered with vinyl, remove the vinyl by twisting it as shown in the diagram.

• Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord. This could cause poor reception.

•If reception is poor, connect an outdoor single vinyl-covered wire to the AM EXT terminal. (Keep the AM loop antenna connected.)

Connecting the Speakers

You can connect the following speakers:

•Two pairs of front speakers to produce normal stereo sound.

•One pair of rear speakers to enjoy the surround effect.

•One center speaker to produce more effective surround effect (to emphasize human voices).

•One powered subwoofer to enhance the bass.

IMPORTANT:

After connecting the speakers listed above, set the speaker setting information properly:

•To obtain the best possible Surround and DSP effect in the main room, see page 29.

•To use the Multi-room function, see “Setting the Front Speakers Either for the Main Room or Sub-room” on page 27.

For each speaker (except for a subwoofer), connect the (+) and (–) terminals on the rear panel to the (+) and (–) terminals marked on the speakers. For connecting a subwoofer, see page 7.

CAUTION:

Use speakers with the SPEAKER IMPEDANCE indicated by the speaker terminals.

Basic connecting procedure

1	2	3	4
	RIGHT	RIGHT	RIGHT
	LEFT	LEFT	LEFT

1Cut, twist and remove the insulation at the end of each speaker signal cable (not supplied).

2Turn the knob counterclockwise.

3Insert the speaker signal cable.

4Turn the knob clockwise.

Connecting the front speakers

You can connect two pairs of front speakers — one pair to the FRONT 1 SPEAKERS terminals, and the other pair to the FRONT 2 / SUB ROOM SPEAKERS terminals.

The speakers connected to the FRONT 2 / SUB ROOM SPEAKERS terminals can be used as follows:

•As the second front speakers in the main listening room

•As the main speakers in the sub listening room when using the Multi-room function.

Right speaker FRONT 1 SPEAKERS Left speaker

FRONT 1 SPEAKERS

+ +

CAUTION :

SPEAKER IMPEDANCE

RIGHT	LEFT	RIGHT	LEFT	4	6	LOW
				8	16	HIGH
–				– SPEAKER LOAD SELECTOR
CAUTION : SPEAKER IMPEDANCE 8			16
FRONT 2 SUB ROOM SPEAKERS

Right speaker	FRONT 2 / SUB ROOM	Left speaker
	SPEAKERS

IMPORTANT for FRONT 1 SPEAKERS connection:

To obtain the best possible output power from the receiver, and to prevent the receiver from being overheated, the receiver has the SPEAKER LOAD SELECTOR which has to be set as follows:

•Set it to the “HIGH” position when the impedance of the front speakers connected is within the range of 8 Ω to 16 Ω.

•Set it to the “LOW” position when the impedance of the front speakers connected is within the range of 4 Ω to 6 Ω.

6