Getting Started
English
7Digital connection
DIGITAL IN
DIGITAL 1 | DIGITAL 2 |
(DBS) | (TV) |
CAUTION: SPEAKER IMPEDANCE 8 16
| You can connect either of |
| the following components |
| to DIGITAL IN terminals. |
B | DIGITAL |
OUT | |
| |
A |
|
DIGITAL
OUT
Before connecting an
optical digital cord,
unplug the protective plug.
DIGITAL
TV
DBS tuner
CD recorder
CD recorder
DIGITAL OUT
PCM/STREAM
B
IN
Connect the CD recorder using the DIGITAL OUT terminal for digital recording.
Now, you can plug the power cord of the unit into the AC outlet.
CAUTIONS:
•Do not touch the power cord with wet hands.
•Do not pull on the power cord to unplug the cord. When unplugging the cord, always grasp the plug so as not to damage the cord.
Notes:
•Keep the power cord away from the connecting cords and the antenna cables. The power cord may cause noise or screen interference.
•The preset settings such as preset channels and sound adjustment may be erased in a few days in the following cases:
–When you unplug the power cord.
–When a power failure occurs.
Putting Batteries in the Remote Control
Before using the remote control, put two supplied batteries first.
1 Press and slide the battery
cover on the back of the remote control.
2 Insert batteries. Make sure to match the polarity: (+) to
(+) and (–) to (–).
3 Replace the cover.
If the range or effectiveness of the remote control decreases, replace the batteries. Use two
Note:
•Supplied batteries are for the initial setup. Replace for continued use.
CAUTION:
Follow these precautions to avoid leaking or cracking cells:
•Place batteries in the remote control so they match the polarity: (+) to (+) and
•Use the correct type of batteries. Batteries that look similar may differ in voltage.
•Always replace both batteries at the same time.
•Do not expose batteries to heat or flame.
When using the remote control, 
aim the remote control directly at 
the remote sensor on the unit. 
Remote sensor
11