Kathrein UFS 822sw, UFS 822si manual Single-cable system Automatic Manual

FIRST INSTALLATION

Single-cable system	Single-cable system
“Automatic”	“Manual”

Note: If there already is a UFS 822 on the system and a second UFS 822 is to be added, the first UFS 822 should be switched on and both tuners should be active, so that the single-cable frequencies for the first receiver remain reserved. The two receivers cannot share the same frequencies.

Note: If there already is a UFS 822 on the system and a second UFS 822 is to be added, you must assign different frequencies to the second UFS 822 (otherwise the receivers will interfere with each other).

A maximum of two UFS 822 receivers can be connected to a 4-SCR system.

Press the ! (green) button to continue with the installation.

Press the  buttons to set the two single-cable frequencies to be used by your receiver.

Then press the !(green) button to obtain the next screen.

Display of the valid single-cable frequencies found by the receiver (example):

Single-cable frequency 0–1400 MHz Single-cable frequency 1–1516 MHz Single-cable frequency 2–1632 MHz Single-cable frequency 3–1748 MHz

The number of searches is limited to 10. If the tenth search is performed and still no success, the system switches to manual mode. It can however be switched back into automatic mode.

22