Kathrein UFS 822si, UFS 822sw manual  buttons

FIRST INSTALLATION

The receiver now checks whether two free single-cable frequencies are available for the receiver to use.

Display of the frequencies selected by the receiver (example):

Single-cable frequency 0–1400 MHz Single-cable frequency 1–1516 MHz

The receiver now automatically performs the configuration (setting the LNB frequency and the LNB type).

Once the automatic configuration has been completed, the received displays an overview for

you. Now press the button.

Press the  buttons and the  button to select the satellites from which you want tuners

1 and 2 to receive signals. Press the  button to confirm your selection; the chosen satellite is then moved into the tuner satellite list on the right.

If you have unintentionally transferred a satellite into the list on the right, you can press the

"(yellow) button to switch between the lists, and

then press the  button to remove the satellite concerned.

When you have selected all the satellites you want, press the ! (green) button.

If the LNB type used in your reception system is a single-cable LNB, the setting must be “Wideband” LNB. If a Universal LNB is used with a single-cable matrix, the setting must be “Universal” LNB (for this, refer to the product information, user instructions and manuals for the LNB and for the matrix).

For “LNB Type” perform here a suitable setting for your reception system, “Wideband” or “Universal”. The “22kHz Control” must be set to “Off” and the “DiSEqC™ Input” must be set to “Disable”.

You can see whether the configuration is correct for your reception system by viewing the test transponder signal strength (selection by pressing

the  buttons).

23