USER PREFERENCES
If the tvtv EPG data are older than 36 hours, or had previously been deleted by the “Invalidate
provided that the button had been pressed to place the receiver in standby mode. The update can be
interrupted by pressing the button a second time.
RECORDING LEADING OFFSET
Here use the buttons to select the number of minutes before the time set in the EPG at which the recording should start. You can choose a value between 1 minute and 10 minutes, in 1 minute increments. The recording will start that number of minutes before the due time. This allows a contingency for small variations in transmission times. Unwanted parts of the recording can later be discarded, as described in the Chapter “Recording List” under “Edit Recordings”, “Cut”.
RECORDING FOLLOWING OFFSET
Here use the buttons to select the number of minutes after the time set in the EPG for which the recording should run on. You can choose a value between 1 minute and 30 minutes, in 1 minute increments. The recording will stop that number of minutes after the due time. This allows a contingency for small variations in transmission times. Unwanted parts of the recording can later be discarded, as described in the Chapter “Recording List” under “Edit Recordings”, “Cut”.
INVALIDATE TVTV-DATA
In this menu you can use the button to delete the stored tvtv data. You can then have the UFS 822
update the tvtv data at the selected time or press to switch your receiver to standby. The receiver automatically starts updating the tvtv data. The progress of the tvtv data update is indicated
pressing the button.
DYNAMIC SI HANDLING
Use the buttons to select “On” or “Off”. When the receiver is switched on, it automatically uses the program names broadcast by the transmitter. Setting this to “Off” allows you to change the program names, and prevents the receiver automatically changing those names back to the broadcast setting.
57
