f
o Bobbin Winding
® For horizontal spool pin
® For additional spool pin
Pull the handwheel out to the right.
Draw thread from the spool
® Guide the thread around the thread guider
(_ Thread through the hole in the bobbin from the
inside to the outside,.
Put the bobbin on the bobbin winder spindle
(_ Push the bobbin to the right°
(_ With free end of the thread held in your hand,
depress the foot control Stop the machine
when it has made a few turns and cut the thread
close to the hole in the bobbin°
(_ Depress the foot control again° When the bobbin
is fully wound, it stops automatically_ Return the
bobbin winder to its original position by moving
the spindle to the left and cut the thread as
shown.,
® Push the handwheel in. The machine will not
function until the clutch is engaged°
NOTE: Position of the bobbin winder stopper is
adjustable for the required amount of
thread on the bobbin (example 1/2 full or
full etc_).
Use a screwdriver and loosen the screw
one turn or less so that you can adjust the
position of the bobbin winder stopper,
Do not take out the screw all the way°
®®
®
®
®® ......J
22